Finishing Machine

This machine is designed to Remove excess rubber from the Automobile Bushes.
It comes with two stations with one for cleaning of Inner face while the another for cleaning of outer face.
Brushes provided are efficient and reliable while they are changeable/replaceable.
The USP of this machine is it has six job holding fixture.

Job holding fixture	Ranging from OD 20mm to 100mm
Machine Footprint	1000mm X 1000mm
Working Height	900 mm
Cycle time per piece	5 seconds
Electrical Mains Power supply	415V, 50 HZ

This machine removes excess rubber from the inner diameter of the Automobile Bushes.
Job clamping operations are pneumatically done which ensures accuracy and durability.
It has two stations with the changeable brushes.

Machine Footprint	800mm X 650mm
Working Height	900 mm
Horizontal displacement of job clamping fixture	150 mm
Useable stroke	110mm
Motor Capacity	0.25 Hp. 2 Nos
Electrical Mains Power supply	415V, 50 HZ

Specific arrangement of brush height can be adapted for multiple diameters of jobs.
This machine has one cleaning station and changeable brush.

Frame Assembly with MS covers & doors.
One cleaning station with changeable brush.
Easily Adjustable brush height with handle for different diameter of Components.
Cleaning length can accommodate multiple components within this range.
Specially designed job holding rods, to load the components.
Motor for rotation of job holding rod.
Pneumatic operated job loading station.
Control Panel to control the quick cycle with easy access to operator.
Localized exhaust duct which can be further connected to your exhaust system.

Machine Footprint	600mm X 1600mm
Working Height	900 m
Cleaning length	410 mm
Job holding fixture	Can accommodate diameter ranging from OD 20 mm to 100mm
Electrical Mains Power supply	415V, 50 HZ

Swaging machines, also known as swagers, are a low-cost way to efficiently point, reduce and form rod, tube or wire.
Based on a simple principle, it is the process of shaping metal (forging) by means of a series of very rapid, blows delivered by rotating hammers and forming dies around a piece of work.
This machine is designed to swagg the bushes after the moulding process.

Pressing capacity	60 Tons
Working Pressure (Max)	300bar
HP Of Electric Motor	10 HP
Working height	900mm
Length & Width of machine	1000x 1000mm
Weight of Machine	1200Kg
Electrical Mains Power supply	415V, 50 HZ

This setup is designed to carry the telescopic cylinder tubes from one grinding station to another station.
The conveyor will be belt and pulley type while Job lifting and passing mechanism will be pneumatically operated, the conveyor will be driven by integrated gear motor.

Frame Assembly with MS Square Pipe and Sheet.
The Conveyor will be Belt and Pulley Conveyor.
Pneumatically operated job Lifting and passing mechanism.
Electrical control panel, with DOL Starter for motor operation
The conveyor will be driven by gear motor integrated the proper synchronization with the machine speed.
Manual adjustment will be provided for the conveyor line so as to match its axis w.r.t. the Grinding machine axis over the time.
The axis adjustment is as follow:
X –Axis: Manual adjustment with the help of lead Screw.
Y –Axis: it will be adjusted through the slot provide on the conveyor Structure (max. 50mm)
Z-Axis: Levelling Pad